$29.95 – $42.95
The AMS REIN Gen 2 is in now in production – ETA Late Q4 2024
Atlas Mounting Solution (AMS) – REIN
*Mount Only: REIN Remote Switch Not Included*
Made in the USA – Full Lifetime Warranty
The AMS REIN Gen 2 is now in production – ETA Late Q4 2024
The first generation of the Atlas Mounting Solution (AMS) REIN was the first member of the AMS family, which brings pressure pad/remote switch integration to the popular AR-15 ATLAS S-ONE handguards offered by Aero Precision and Ballistic Advantage. Now, we bring you Gen 2 – designed around the latest generation of Cloud Defensive switches. The two piece locking clamp design utilizes factory REIN switch hardware for a secure and reliable fit.
For installation guidelines, please scroll to the bottom of this page
| Model | One Button, Two Button |
|---|
The recoil lugs on the backside of the mounts should sandwich the thinner support sections in the upper rail cutouts.
Incorrectly installed in this example, the recoil lugs sit free in the larger overall channel. This allows for potential undesired movements fore and aft in the channel.
*NOTE: Handguard dimensions shown above are representative of the 12 inch ATLAS S-ONE model
The ATLAS S-ONE line of handguards does not utilize universal dimensions for the length of the channel cutouts, only for their height, and the distance between. For example, the channels on the 15 inch S-ONE are approx. .975″ long, whereas the channels on the 7 inch model are approx. .885″. As a result, filling the entire channel would require 5 distinct models to be produced, one for each handguard length, which is more restrictive to end users, inefficient in manufacturing, and generally cost prohibitive as a result.
Don’t worry though, there are still plenty of options for mounting locations, across all S-ONE lengths, more than are actually usable on the longer handguards, since you are limited, by cable length, as to how far rearward you can mount.
1 – Pre-position your mount on your handguard to test ergonomics and plan cable routing.
2 – When in the desired position, press the two halves into place on the handguard, with the switch still in place. The lugs may be very tight and require some light pressure to seat fully.
3 – After ensuring proper seating in the channels, press fit the two hex nuts from the REIN switch factory mounting hardware and insert the factory mounting screws, aligning all three components: the two mounting halves and the switch itself.
4 – Now, with everything lined up and routed as desired, tighten the two screws to officially lock the mount in place. Aim a half a turn past hand snug for proper torque.
For any questions or general support regarding your AMS -REIN, please reach out via our support form and we will get back to you ASAP
There are no reviews yet.